​
Powering On the LiteRTK

  1. Hold the power button for about 3 seconds.
  2. The icon on the left will light up green and then transition to a solid orange, indicating that the device is powered on and ready. In addition, you will hear two beeps.

​
Using the LiteRTK as a Rover

​
Setting up Wifi Mode

  1. Set up a mobile hotspot or WiFi network with the following credentials:

    • SSID (Network Name): LiteRTK
    • Password: 12345678

  2. Once your mobile hotspot or WiFi matches these credentials, the LiteRTK will automatically connect to the network.

  3. After connecting to the WiFi, the LiteRTK will establish a connection to an NTRIP account on its own. No additional action is required unless the connection fails.

​
Handling WiFi Connection Failure

If the LiteRTK fails to connect via WiFi or setting up a WiFi network is not feasible, you will need to manually configure NTRIP (Networked Transport of RTCM via Internet Protocol) credentials using the SW Maps app. This can be found in section 3.3.

The NTRIP information to enter is as follows:

  • Username: xxxx (this information will be given to you)
  • Password: xxxx (this information will be given to you)
  • Mountpoint: AUTO
  • NTRIP caster address: rtk.geodnet.com
  • Port: 2101